General-machine-products CD-28 Adams Manual Bedienungsanleitung

ADAMS MODEL CD-22 MODEL CD-28 CONTINUOUS DUTY WINCH Installation, Operation and Maintenance Manual General Machine Products Co., Inc. 3111 Old Lin

10 Make certain that the wire rope is properly attached to the drum and that no less than one half of the first lay remains on the drum at all times.

11 LUBRICATION Reverse bending of the wire rope should always be avoided or kept to a minimum. Wire rope should always be under tension whe

12 Winch Input Gear Ratio Control Valve Position Winch Line Speed (ft./min.) 30 GPM Bare drum Full Drum Bare Drum Full Drum 19.9:1 High 10,000

2 TABLE OF CONTENTS BASIC DETAILS …………………………………………………………... Page 2 GENERAL ………………………………………………………………….. Page 2 MAJOR COMPONENTS ………………………………………………….

3 MAJOR COMPONENTS • Winch Drive Assembly • Final Drive Assembly • Safety Brake Assembly • Drum Assembly • Clutch Assembly • Drag Brake Assembly

4 Sufficient clearance should be allowed between the front body panel or other re-strictive members and the winch to permit normal maintenance. For

5 DISC TYPE DRAG BRAKE On units manufactured before February 15, 1980, there are three control positions for the winch clutch and disc type drag brake

6 CALIPER BRAKE ASSEMBLY INSTALLATION The primary brake assembly P/N 17134 will be mounted at the factory on the left side, top surface of the f

7 IMPORTANT NOTE: WHEN THE WIRE ROPE IS BEING PAYED-OUT UN-DER POWER, THE WINCH IS BEING DRIVEN AGAINST THE BRAKE. CONSEQUENTLY, EXCESSIVE HEAT WILL

8 To control the drum speed in free spool: For winches with a disc type drag brake, pull the single clutch control lever all the way out and hold ac

9 The oil level plug should always be removed before adding oil to avoid over-filling. The automatic brake housing should be checked after seventy-f