Page 1 of 16 General Machine Products Co., Inc. 71500 Sierra Cable Lasher Operation and Maintenance All rights reserved. No part of this publicat
Page 10 of 16 General Machine Products Co., Inc. 4. Transferring the Sierra Around a Pole 6.0 OPERATION PROCEDURE Transferring your lasher arou
Page 11 of 16 General Machine Products Co., Inc. 7.0 MAINTENANCE AND SERVICING Monthly Lubrication Points and Adjustments O G O O Grease Oil O
Page 12 of 16 General Machine Products Co., Inc. The lashing wire won’t pay out: This indicates the wire isn’t threaded properly. Refer to “Loadi
Page 13 of 16 General Machine Products Co., Inc. Lashing Wire Clamp Installation APPENDIX 1
Page 14 of 16 General Machine Products Co., Inc. Stainless Steel Lashing Wire is used in your lasher to lash an aerial cable or combination of ca
Page 15 of 16 General Machine Products Co., Inc. D Lashing Wire Clamp Perfect for temporary and permanent terminations or grounds, this all steel
Page 16 of 16 General Machine Products Co., Inc. GMP • 3111 Old Lincoln Hwy • Trevose, PA 19053 • USA TEL: +1-215-357-5500 • FAX: +1-215-357-621
Page 2 of 16 General Machine Products Co., Inc. REVISION HISTORY: Rev No. Date Details Author 01 05-2012 Original issue A.Konschak 02 02-20
Page 3 of 16 General Machine Products Co., Inc. CONTENTS 1.0 Introduction 2.0 Safety Instructions 3.0 General Description 4.0 Specifica
Page 4 of 16 General Machine Products Co., Inc. Founded by engineer George M. Pfundt in 1936, GMP started op-erations in a downtown Philadelphia
Page 5 of 16 General Machine Products Co., Inc. 2.0 SAFETY INSTRUCTIONS IMPORTANT PRECAUTIONS Advance planning for safety should include the fo
Page 6 of 16 General Machine Products Co., Inc. 3.0 GENERAL DESCRIPTION General Information: The GMP Sierra pull type cable lasher weighs just 1
Page 7 of 16 General Machine Products Co., Inc. 6.0 OPERATION PROCEDURE C. Feed the loose end of the lashing wire thru the guide bushing. D.
Page 8 of 16 General Machine Products Co., Inc. 2. Preparing the Sierra lasher for Operation A. Open the strand lock (a), cable placing roller (b
Page 9 of 16 General Machine Products Co., Inc. 3. Termination Of Lashing Wire 6.0 OPERATION PROCEDURE A. Once you’ve reached the end of the pul
Kommentare zu diesen Handbüchern